Fluke 789 ProcessMeter with TL71 Test Leads

A maintenance and calibration tool that will be at home in every instrumentation technicians tool box, the Fluke 787 process meter"¢ combines a DMM and aâ loop calibratorâ in one rugged, handheld tool, for about what you would expect to pay for a loop calibrator alone. Based on the trusted Fluke 87 DMM, the 787 adds the ability to measure, source, and simulate DC loop current with 0.05 percent accuracy and 1 MA resolution.

• 1000V overload protection on V, Ohms, frequency, and 150V overload protection on mA, backed up by a 440 mA 1000V fuse
• Runs about 50 hours typical (measurement), 12 hours typical (sourcing 12 mA) on one 9-volt alkaline battery
• Clear LCD display with Backlight
• Current Measurement Range: 0 to 30 mA DC
• 24V loop power supply
• 25-Percent Manual Step plus Auto Step and Auto Ramp on mA output
• Built-in, selectable 250-Ohm Hart resistor
• 0 and 100-Percent buttons to toggle between four and 20 mA sourcing for a quick span check
• Very large dual display with enhanced backlight with 2 brightness settings

WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.

• This item cannot be shipped to PO Boxes.
• This item can be shipped only within the U.S.

• UPC: 095969112192 
• Mfr's Part #: FLUKE-789 

• Return Policy
• Shipping Methods
• Order Acceptance Policy